CHECK OUT OUR COMMERCIAL TRAINING COURSES!

To get the full low down on our high efficiency commercial boiler ranges, why not book yourself onto an Ideal training course!

We offer the following courses throughout the year at our Hull training centre:

• three day Concord Super range – Series 2, 3 and 4 and Super Plus
• three day Concord CX range – from CX140-340, CXD, CXi, CX40-100 and new models CXA, CXS and CXSD
• one day Imax

The Concord Super course is designed to provide the engineer with all the necessary information and practical hands on experience to commission, service and fault find on the following modules: Series II, Series III, Series IV and Super Plus.

Practical sessions within the course cover servicing, setting stats, fault finding and commissioning.

The Concord CX course covers installation parameters, commissioning, servicing and fault finding on the old and new CX range.

The course starts with an explanation of the correct pipework, flueing and electrical connections for single and multiple boilers.

It then leads into boiler construction and controls, and the printed circuit boards are fully explained. Servicing and fault finding procedures are also covered. The one day courses for the Imax and Maximiser boilers are based around installation, servicing and fault finding.

For more information about any of these courses, contact our Technical Training Administrators on 01482 498432.